Dynamic frictional behaviour of synthetic sandstone under low normal stress and seismic excitation

  • Kuo Chen Lee CECI Engineering Consultants Inc., Taipei, China
  • Rolando P. Orense University of Auckland, Auckland, New Zealand http://orcid.org/0000-0002-0581-9563
  • Fu Shu Jeng National Taiwan University, Taipei, China

Abstract

Both New Zealand and Taiwan are located in the Pacific ring of fire, the most active seismic zone in the world, and therefore slope failures triggered by seismic excitation are frequent and they sometimes could cost severe damage to life and property. Earthquake induced slope failure, especially rock-block sliding failure, is usually analysed using friction coefficient measured at the sliding-interface. A tilt test is a convenient test for measuring the required values under static condition, but the applicability of measured results to analyse block sliding under dynamic condition requires further investigation. In this paper, a series of static tilt test and dynamic shaking table test were performed to simulate block sliding with base excitation. The results were compared in terms of measured sliding thresholds, and the causes of the differences were discussed. Tests on synthetic sandstone showed that friction coefficients measured by tilt tests were always larger than the ones derived by shaking table tests. Furthermore, sliding thresholds increased with increasing shaking frequency, suggesting that the sliding threshold is non-constant under excitation. In addition, the sliding threshold is lower at higher contact stresses on the sliding surface, showing that the sliding threshold varies with normal stress. This study identified the limitations of the tilt test when applied to dynamic problems, and recommended that realistic sliding threshold can only be obtained using dynamic tests, such as shaking table tests.

References

Barbero, M., Barla, G. and Zaninetti, A. (1996). “Dynamic shear strength of rock joints subjected to impulse loading,” International Journal of Rock Mechanics & Mining Sciences, 33 (2), 141-151. DOI: https://doi.org/10.1016/0148-9062(95)00049-6

Barton, N. and Choubey, V. (1977). “The shear strength of rock joints in theory and practice,” Rock Mechanics, 10, 1-54. DOI: https://doi.org/10.1007/BF01261801

Chaudhuri, S.R. and Hutchinson, T.C. (2005). “Characterizing frictional behavior for use in predicting the seismic response of unattached equipment,” Soil Dynamics and Earthquake Engineering, 25, 591–604. DOI: https://doi.org/10.1016/j.soildyn.2004.11.022

Chiang, T.L., Wang T.T., Lee, K.C. and Jeng, F.S. (2009). “Analysis of pyramidal block slide induced by seismic excitation,” Journal of the Chinese Institute of Engineers 32 (1), 107-122. DOI: https://doi.org/10.1080/02533839.2009.9671487

Hencher, S. R. (1980). “Friction parameters for the design of rock slopes to withstand earthquake loading,” Design of Dams to Resist Earthquake, ICE, London. DOI: https://doi.org/10.1680/dae.01237.0012

Huang, C.S., Chen, M.M. and Hsu, M.I. (2002). “A preliminary report on the Chiufenershan landslide triggered by the 921 Chi-Chi earthquake in Nantou, central Taiwan,” Terrestrial, Atmospheric and Oceanic Sciences 13, 387-395. DOI: https://doi.org/10.3319/TAO.2002.13.3.387(CCE)

Jafari, M.K., Pellet, F., Boulonb, M. and Amini Hosseini, K. (2004). “Experimental study of mechanical behavior of rock joints under cyclic loading,” Rock Mechanics and Rock Engineering, 37 (1), 3-23. DOI: https://doi.org/10.1007/s00603-003-0001-4

Jeng, F.S., Weng, M.C., Lin, M.L. and Huang, T.H. (2004). “Influence of petrographic parameters on geotechnical properties of tertiary sandstones from Taiwan,” Engineering Geology 73, 71-91. DOI: https://doi.org/10.1016/j.enggeo.2003.12.001

Jibson, R.W. and Keefer, D.K. (1993). “Analysis of the seismic origin of landslides: Examples from New Madrid seismic zone,” Geological Society of America Bulletin, 105, 521-536. DOI: https://doi.org/10.1130/0016-7606(1993)105<0521:AOTSOO>2.3.CO;2

Kamai, T., Wang, W.N. and Shuzui, H. (2000). “The landslide disaster induced by the Taiwan Chi-Chi earthquake of 21 September 1999,” Landslide News, 13, 8-12.

Kokusho, T. and Ishizawa, T. (2007). “Energy approach to earthquake-induced slope failures and its implications,” Journal of Geotechnical and Geoenvironmental Engineering, 133 (7), 828-840. DOI: https://doi.org/10.1061/(ASCE)1090-0241(2007)133:7(828)

Mendez, B.C., Botero, E. and Romo, M.P. (2009). “A new friction law for sliding rigid blocks under cyclic loading,” Soil Dynamics and Earthquake Engineering, 29, 874-882. DOI: https://doi.org/10.1016/j.soildyn.2008.09.004

Newmark, N.M. (1965). “Effect of earthquakes on dams and embankments,” Geotechnique, 15 (2), 139-160. DOI: https://doi.org/10.1680/geot.1965.15.2.139

Park, B.K., Jeon, S. and Lee, C.S. (2006). “Evaluation of dynamic frictional behavior of rock joints through shaking table test,” Tunnelling and Underground Space Technology, 21, 427. DOI: https://doi.org/10.1016/j.tust.2005.12.069

Shou, K.J. and Wang, C.F. (2003). “Analysis of the Chiufengershan landslide triggered by the 1999 Chi-Chi earthquake in Taiwan,” Engineering Geology, 68. 237-250.

Terzaghi, K. (1950). “Mechanisms of landslides, In Application of Geology to Engineering Practice (Berkeley Volume),” edited by S. Paige, Geological Society of America, New York, 83-123.

Wartman, J., Riemer, M.F., Bray, J.D. and Seed, R.B. (2000). “Newmark analysis of a shaking table slope stability experiment,” Geotechnical Earthquake Engineering and Soil Dynamics, 3, 778-789.

Wartman, J., Bray, J. D. and Seed, R.B. (2003). “Inclined plane studies of the Newmark sliding block procedure,” Journal of Geotechnical and Geoenvironmental Engineering, 129 (8), 673-684. DOI: https://doi.org/10.1061/(ASCE)1090-0241(2003)129:8(673)

Published
2012-06-30
How to Cite
Lee, K. C., Orense, R. P., & Jeng, F. S. (2012). Dynamic frictional behaviour of synthetic sandstone under low normal stress and seismic excitation. Bulletin of the New Zealand Society for Earthquake Engineering, 45(2), 71-76. https://doi.org/10.5459/bnzsee.45.2.71-76
Section
Articles